Available for Special order.
New variant of the Electron Fuzz Custom with 4 Control Voltage inputs. **all orders include a retro style or vintage panel meter.
Order time: 5-7 weeks
Special order deopsit $170
Domestic shipping: Free
Aprox. International Shipping: $39.00
***New Control voltage features. +5 volts controls “Hurt” “Pain” “Feedback Noise OSC” and “Distortion output” the EFCcv also has a new input attenuation knob.
***About special orders: The deposit paid is applied in full towards your build. We invoice for the remaining balance when your box is ready to ship. The look of custom order may vary depending on type of vintage meter used and finish of wood. Look may vary with different meters. I always try to use the absolute best meters for these builds but its not uncommon for the vintage meters to have dings and scratches. A lot of work goes into restoring the meters. Please be aware Im not able to just grab a ready to go meter off a shelf. They must be tested, modded and restored. This tends to add time to the builds. Many do not pass the test. I’ve found over the years decent ones are getting harder to come by. (07/04/2021)
****This is an advanced modded version of the regular Electron Fuzz Custom. The “EFCcv” has a number of features not available in the aluminum etched boxed versions. With the addition of 4 Control Voltage inputs to control the major features the sonic possibilities have been even further expanded.
The inputs are large format 1/4″. The top panel is a very thick 1/8th inch aluminum plate. the EFCcv Requires a standard 9volt power supply (not included)
“Distortion Out” is the independent distortion volume. The “Output” CV controls the distortion out and works as a simple VCA. “Hurt” and “Pain” are tone controls tied into different gain stages. Both are controllable via CV.
The “Bleed Out” knob controls a clean mix. If your using this with keyboards or with guitar and wish to maintain the integrity and warmth of your original signal you can mix in a separate boosted clean signal. Both clean and distorted signals can be controlled separately. This works very well with bass guitar and helps retain the low end.
The “Decay” toggle engages a couple of germanium diodes. They add a saturation to your clean signal only. Adds a nice flavor when mixing that clean signal back in with the fully distorted signal.
The “FB OSC” or “Feedback oscillation” can make the pedal sound almost 8bit or add some interesting screeching characteristics to your sound. This effect is still separate from the clean mix increasing the ability to add texture to a warmer boosted signal. The CV control can create ramps up or down in pitch.
If you have any special finishing request things like color stain or types of meters please contact me:
Click here to e mail directly