432k Rev2 with Standard Meter (b-stock)

Price: $324 (Reg $349)
Domestic shipping: $FREE
Aprox. International Shipping: $39 – $65
(18volt supply not included) Get one the ECB004

Shipping with cream knobs and ox blood red knobs.

This item has sold.

For your consideration:

I’ve got one B- Stock 432k Rev 2.1 at a discounted price. The scuff is along a bottom edge. Not easy to see. I question my sanity for even offering it as a B-Stock. This unit has the 3 oxblood knobs. Same unit that is pictured.

This is the newly redesigned 432k rev2.1 …has a small change from the original. The Transistor drive knob used to be configured with a direct connection to the emitter of a transistor. This created a static sound when turning the knob, much like a finger dragging on a microphone. While everything functioned as designed a few people who didn’t read the manual assumed the potentiometer was “dirty”.

So I rebuilt that gain stage to work with an internal control voltage severing the direct connection with the sound path. The result is a very smooth operation and a better user experience.

More on the 432k rev2:

…Because vintage meters are limited and hard to find here is the “Standard meter” version. Meter is illuminated!
This model has a a couple of different mods not on the normal version. A sustain knob that works much like the sustain on the Muff pedals, additional gain stage clipping for a smoother fuzz. Those mods can drastically change the tone and texture of the pedal.  In addition to the mods I’ve used a different set of transistors to give the unit a slightly different sound than the regular 432k Distortion box. This is a large pedal. Its about the same size foot print as the 5.5×7.5 wood boxes.

…The 432k Distortion box is all about signal routing. One distortion circuit with an active hybrid diode/transistor ladder filter (with resonant feedback) for tone control. Another with a clean pass signal. Both signals are merged together and “glued” through a transistor drive and op amp style fuzz.  Also equipped with CV in for filter control. ***Use a CV to control the filter.
Things I enjoy about this pedal:

  • Hyper Fuzz tone
  • Hybrid Diode/Transistor ladder filter.
  • Enhanced resonant feedback for more expressive tones
  • Clean pass lets you bring a quality signal back into the compressed distortion
  • Op Amp style fuzz at end of signal chain. Dial in harsh tones and smooth them out.
  • Great for guitars and keyboards
  • CV filter control. Use CV in to control filter with modular gear, synth or CV pedal.
  • Low cut toggle for guitar use.
  • True Bypass

• Knob controls:

Distortion: Volume of Distortion
Filter: Filter Frequency
Resonance: Active resonant feedback
Clean: Clean signal
Low Cut: low end roll off
Transistor: Transistor gain/drive
Op Amp: Op Amp Fuzz
Feedback: Noise loop (works best with sequenced sounds)
Output: Volume

**Requires a regulate 18volt DC Supply. Standard negative tip with a min of 150ma. (not included) Will run on 12volts for a dirtier sound. Lower voltage will affect the smoothness of the filter.

***All purchases done through Paypal. Units are always shipped ASAP. Please note when purchasing from eBay shipping charges may be vary.

****International shipping can vary. Typically I will credit back any difference when your unit is ready and I am able to verify exact shipping to your specific location.